NCPlot Forums

Posted: **Sun May 21, 2006 4:50 pm**

Hi Scott,

i see you have fixed the bug with the coordiante variables #5001 and so on when a G65 call comes with a axis adress letter. But now i have another question. Why is the #5001, #5021 value on lathe setup the half of the axis position? On Fanuc lathes this value is not the half (on diameter axis). Can you make a selection in the setup screen were this can be selected?

best regards
Armageddon

Posted: **Sun May 21, 2006 8:01 pm**

Armageddon,

No, it shouldn't do that when diameter is selected. I'll see if I can get this fixed. Thanks for being patient with me on this, I'll get it right sooner or later.

Thanks,
Scott

Posted: **Fri May 26, 2006 2:56 pm**

Hi Scott,

if you fixed this can you make that the variables #5001 and so on be always displayed in the show variables screen?

Markus

Posted: **Fri May 26, 2006 4:46 pm**

Markus,

Sure, I can do that.

Scott