The plot seems to skip any block that contains this command. Is there something I don't have configured correctly?
EDIT: disregard...appears to have been fixed on the latest revision.
G09 exact stop on Haas lathe
2 posts
• Page 1 of 1
G09 exact stop on Haas lathe
by gearman » Fri Feb 23, 2007 2:51 pm
-
gearman - Posts: 2
- Joined: Fri Feb 23, 2007 2:16 pm
- Location: NE Ohio
by scottmartinez » Fri Feb 23, 2007 4:04 pm
This was fixed recently, make sure you have the latest version of NCPlot. The RC4 download has been updated a few times, so just re-download and re-install.
Scott
Scott
-
scottmartinez - Site Admin
- Posts: 215
- Joined: Sat Mar 11, 2006 8:49 pm
2 posts
• Page 1 of 1
Return to Questions / Comments
Who is online
Users browsing this forum: No registered users and 16 guests