NCPlot Forums

NCPlot discussion board
http://www.ncplot.com/forums/

G09 exact stop on Haas lathe

http://www.ncplot.com/forums/viewtopic.php?f=2&t=104

Page 1 of 1

G09 exact stop on Haas lathe

PostPosted: Fri Feb 23, 2007 2:51 pm
by gearman
The plot seems to skip any block that contains this command. Is there something I don't have configured correctly?

EDIT: disregard...appears to have been fixed on the latest revision.

PostPosted: Fri Feb 23, 2007 4:04 pm
by scottmartinez
This was fixed recently, make sure you have the latest version of NCPlot. The RC4 download has been updated a few times, so just re-download and re-install.

Scott
All times are UTC - 5 hours [ DST ]
Page 1 of 1
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/