Entity Info
2 posts
• Page 1 of 1
Entity Info
by Chuck » Mon May 07, 2007 2:51 pm
I noticed that in a Lathe dia. setup if I look at the entity info for a rad that is less than 1 quadrant the endpoint is off. I I export the geometry to dxf and open it in a CAD package the actual geometry is correct. The acual poins look right it's the angle that is off.
Chuck
"Outside of a dog, a book is
mans best friend. Inside a dog
its too dark to read"
-Groucho Marx
"Outside of a dog, a book is
mans best friend. Inside a dog
its too dark to read"
-Groucho Marx
-
Chuck - Posts: 5
- Joined: Fri Jan 19, 2007 5:07 pm
2 posts
• Page 1 of 1
Return to Questions / Comments
Who is online
Users browsing this forum: No registered users and 21 guests