by SD » Sun Jun 03, 2007 10:10 am
Scott
Just installed the new V2.02 and wanted to ask you how can I make the default extention to be *.
Noticed in the list of new features it was something you've worked on, but can't seem to figure out if it needs to be set or is it something the program just remembers from the last time.
I have loaded a program by specifying *.*.
I then used save-as, unclicked .txt and saved as 123 .
I now went to load a new program, the standard .nc .dat etc etc file extentions became the default again.
Now.
If I just loaded a program, backplotted only and then loaded another, then all was fine as the *. did remain the default. It is only after using save that it changes back.
Am I missing something?
In any case, thank you for listening. I'm becomoing quite fond of the program and started to use it for stuff I didn't even intend to in the beginning.