#5001
Posted: Wed Dec 12, 2007 6:49 pmSO I DIDN'T UNDERSTAND ABOUT #5001,5002.
HAS IT BEEN FIXED OR NOT?
HAS IT BEEN FIXED OR NOT?
I didn't know it was broken, can you explain the problem?
Scott
Page 1 of 1
Posted: Wed Dec 12, 2007 6:49 pmPosted: Wed Dec 12, 2007 7:33 pmPosted: Thu Dec 13, 2007 6:02 pmSCOTT
VARIABLES 5001,5002,5003 MUST REMEMBER LAST POSITIONS FOR X,Y,Z. BUT WHEN I SPECIFY THEM, TOOL DOES NOT GO TO ORIGINAL COORDINATES.
FRAGMENT OF PROGRAM
G0G90G54X5.Y6.
#1=#5001
#2=#5002
X10.Y10.
X#1Y#2
TOOL IS TO GO TO X5.Y6.
BUT SOFTWARE DOES NOT UNDERSTAND IT AND TOOL GOES TO X0 Y0
VARIABLES 5001,5002,5003 MUST REMEMBER LAST POSITIONS FOR X,Y,Z. BUT WHEN I SPECIFY THEM, TOOL DOES NOT GO TO ORIGINAL COORDINATES.
FRAGMENT OF PROGRAM
G0G90G54X5.Y6.
#1=#5001
#2=#5002
X10.Y10.
X#1Y#2
TOOL IS TO GO TO X5.Y6.
BUT SOFTWARE DOES NOT UNDERSTAND IT AND TOOL GOES TO X0 Y0
Posted: Thu Dec 13, 2007 7:02 pmI tried your example and I see what you mean. I'll have to look into this to see what the problem is.
Thanks,
Scott
Thanks,
Scott