G84

NCPlot questions or comments

G84

Postby SMAT » Fri May 29, 2009 8:06 am

Hi Scott,

I used a G84 in G19 plane and only this canned cycle doesn't work ???
SMAT
 
Posts: 39
Joined: Thu Aug 31, 2006 3:56 pm
Location: Quebec / Canada

Re: G84

Postby scottmartinez » Fri May 29, 2009 9:59 pm

Hi,

Please check that you are running version 2.06. Versions earlier than this did not support canned cycles in the G18/G19 planes.
If you are running version 2.06 and the G84 cycle is the only one that doesn't work then go into it's configuration folder and delete the file "G840.PRG". Then copy the file "G810.PRG" and rename it "G840.PRG". The config folder is at "\Program Files\NCPlot v2.06\Config\*config name*".

Thanks,
Scott
User avatar
scottmartinez
Site Admin
 
Posts: 215
Joined: Sat Mar 11, 2006 8:49 pm

Re: G84

Postby SMAT » Thu Jun 04, 2009 8:40 am

Ok tanks...
I'm running 2.06 and 2.07b1

bye !
SMAT
 
Posts: 39
Joined: Thu Aug 31, 2006 3:56 pm
Location: Quebec / Canada


Return to Questions / Comments

Who is online

Users browsing this forum: No registered users and 1 guest

cron