G84
Posted:
Fri May 29, 2009 8:06 am
by SMAT
Hi Scott,
I used a G84 in G19 plane and only this canned cycle doesn't work ???
Re: G84
Posted:
Fri May 29, 2009 9:59 pm
by scottmartinez
Hi,
Please check that you are running version 2.06. Versions earlier than this did not support canned cycles in the G18/G19 planes.
If you are running version 2.06 and the G84 cycle is the only one that doesn't work then go into it's configuration folder and delete the file "G840.PRG". Then copy the file "G810.PRG" and rename it "G840.PRG". The config folder is at "\Program Files\NCPlot v2.06\Config\*config name*".
Thanks,
Scott
Re: G84
Posted:
Thu Jun 04, 2009 8:40 am
by SMAT
Ok tanks...
I'm running 2.06 and 2.07b1
bye !