Shift
Posted:
Wed Jul 28, 2010 4:39 pmby SMAT
Hi Scott,
I used - SHIFT - function in Z axis but the retract -R- in canned cycle was not changed.Is it possible, for the retract -R- , to shift too ?
bye !
Re: Shift
Posted:
Sat Jul 31, 2010 12:35 pmby scottmartinez
Hello,
When using the shift tool to shift the Z axis, only Z axis coordinates are changed. If you need to shift other addresses as well, then you will need to use the Address Adjustment tool. To keep it simple you could use a script like the one I've attached. It asks for a Z shift amount and then runs the shift tool followed by the address adjust tool to shift the "R" values. To use this script, unzip it and place it in the \Program Files\NCPlot v2.07\Scripts folder.
Thanks,
Scott