alarm offset number
Posted: Tue Dec 04, 2012 10:41 am
Hi Scott,
I use NcPlot 2.3 beta 2 and when I plot the program It generate alarm (PLEASE SPECIFY AN OFFSET NUMBER) when reading this line :
G90G10L12P763R0.01
But this line is ok(Fanuc)
I think you used a Mitsubishi control and it's probably correct to call an alarm, but is this possible to "jump" this check ?
Thanks
I use NcPlot 2.3 beta 2 and when I plot the program It generate alarm (PLEASE SPECIFY AN OFFSET NUMBER) when reading this line :
G90G10L12P763R0.01
But this line is ok(Fanuc)
I think you used a Mitsubishi control and it's probably correct to call an alarm, but is this possible to "jump" this check ?
Thanks