Page 1 of 1
Missing lines
Posted:
Mon May 20, 2013 11:56 am
by Pysiek
I just downloaded the trial version and when I loaded my dxf file it shows 2 lines missing. I assume there are some settings that need to be changed. But where? Please check the attached image for reference. I marked the locations of missing lines in red.
Re: Missing lines
Posted:
Mon May 20, 2013 5:00 pm
by scottmartinez
Can you post or email the DXF drawing to me?
Thanks,
Scott
Re: Missing lines
Posted:
Tue May 21, 2013 4:30 pm
by Pysiek
Sure. Sorry that I did it so late but I haven't received any email that somebody posted an answer here. The .dxf extension is not allowed to be posted here. Please give me your emial
Re: Missing lines
Posted:
Tue May 21, 2013 4:42 pm
by scottmartinez
You can send it to
scottmartinez@ncplot.comThanks,
Scott
Re: Missing lines
Posted:
Tue May 21, 2013 4:44 pm
by Pysiek
Just send it to you
Re: Missing lines
Posted:
Wed May 22, 2013 4:25 pm
by scottmartinez
I took a look into this and it seems to be a problem within NCPlot. It looks like the polyline is not being closed properly. If you can explode the polyline before you save the drawing then that should import fine.
Thanks,
Scott
Re: Missing lines
Posted:
Mon May 27, 2013 11:36 am
by Pysiek
OKay Scott I will try that. One more time sorry for the late reply but I have forgot to check the option to notify me each time somebody will post reply to it.