Page 1 of 1
address
Posted:
Thu Aug 22, 2013 3:47 pm
by SMAT
Hi Scott,
I have a problem with some addresses when I call a subroutine...see attachement
thanks
Re: address
Posted:
Tue Sep 03, 2013 4:28 pm
by scottmartinez
When using G66 the block parameters don't actually appear in the local variables until a motion block is encountered. Did you confirm that these addresses were incorrect after the subprogram execution began?
Thanks,
Scott
Re: address
Posted:
Mon Sep 09, 2013 11:35 am
by SMAT
yes, thes addresses was incorrect after sub execution began !