address

NCPlot questions or comments

address

Postby SMAT » Thu Aug 22, 2013 3:47 pm

Hi Scott,
I have a problem with some addresses when I call a subroutine...see attachement

thanks
Attachments
NCPlot v2 problem.png
NCPlot v2 problem.png (56.11 KiB) Viewed 10830 times
SMAT
 
Posts: 39
Joined: Thu Aug 31, 2006 3:56 pm
Location: Quebec / Canada

Re: address

Postby scottmartinez » Tue Sep 03, 2013 4:28 pm

When using G66 the block parameters don't actually appear in the local variables until a motion block is encountered. Did you confirm that these addresses were incorrect after the subprogram execution began?

Thanks,
Scott
User avatar
scottmartinez
Site Admin
 
Posts: 215
Joined: Sat Mar 11, 2006 8:49 pm

Re: address

Postby SMAT » Mon Sep 09, 2013 11:35 am

yes, thes addresses was incorrect after sub execution began !
SMAT
 
Posts: 39
Joined: Thu Aug 31, 2006 3:56 pm
Location: Quebec / Canada


Return to Questions / Comments

Who is online

Users browsing this forum: No registered users and 5 guests

cron