NCPlot Forums

Posted: **Tue Apr 17, 2007 5:30 pm**

Scott,

I have Machinist Toolbox on my computer but it did not link when I installed NCPlot. Is there a way to manually do this?

Donnie

Posted: **Tue Apr 17, 2007 9:30 pm**

Hi Donnie,

You must have version 9.x of the Machinist Toolbox ActiveX. Note that this must be the *ActiveX* version and not the standalone version of Machinist Toolbox. Is this what you have?

Scott

Posted: **Wed Apr 25, 2007 11:50 am**

Thanks Scott,

I have version 7. something, guess it's time to upgrade.

Posted: **Thu May 03, 2007 2:32 pm**

Scott,

I upgraded to v9.21, uninstalled then reinstalled NCPlot but it did not link to Machinist Toolbox, what do I need to do?

Posted: **Thu May 03, 2007 4:55 pm**

Hmmmm..... I'll have to check on this and let you know what I find. I'm not sure exactly what version I have, yours may even be newer.

Scott

Posted: **Sun May 06, 2007 3:15 pm**

Donnie,

OK, I've got this fixed now. NCPlot was referencing a particular version of Machinist ToolBox. I've fixed it so that it should work with any version of the ActiveX. The bad news is that this fix didn't make into the last update, but will be in the next one.

Thanks,
Scott