NCPlot Forums

Hi,
I have the beta version running on winxp and no problems. That is until today. I cannot find the text to g-code command under the tools menu. I even tried to set a shortcut key for it and it's a no go. Do I have to give up the beta version and install the last one? I love the xt to code, along with the address adjustment tools I am able to engrave on a diameter in an old haas indexer, way cool.
-Don

Hi Don,

The Text to G-Code and a few other tools are not available when you have NCPlot set to Lathe mode. To switch back to mill mode either switch to a mill configuration or go into the machine configuration and change back to the mill machine type.

Scott