Scott
I've been experimenting with nc plot - everything!
I'm now playing with the macros
I have either a lack of understanding or I have found a possible bug
(Note - I suspect the former), but even if it's me - it should not crash the program.
Try:
Tools/MacroTranslator / Circle Pocket.mac
Enter the values:
X = 25
Y = 25
Z Finish depth = -5
Approach Plane = 0 - - - Not quite sure what this is!
Tool diameter Offset No. = 3 ( I've assumed this is one half of the tool size in mm)
Radius = 25
Radial Step over 5 - - - Again not sure what this is - unless it is the amount the tool retracts at each pass
Z step = -1 - - - i.e. go down 1 mm every pass
Cutting Direction = 0
Feedrate = 25
This will crash the macro everytime, and freeze NCplot
What am i doing wrong?
Regards
Clik!