by dixonc » Mon Feb 09, 2009 5:00 am
Hi Scott,
I have been trying all resolution settings, on the lathes and still get the same result, but a setting of 1.0 on the mills gets the correct times. I figured the problem to be the F codes which were posted with out any point. I am happy with the result here, as we checked it against the machine and it is within 10 seconds.
The other thing I have noticed is that Mastercam X3, gives the same run time as Nc Plot, for the lathes. These are positive X values, by the way.
Your "address adjustment" tool is fantastic. I never knew I had so many uses for it. Thanks a million. Hope you figure out the lathe run time estimation.
Good Luck
DixonC